Double Track Cross (2X2)
Have you ever had the problem of crossing tracks going parallel to each other. And there was not enough space (width) to build a proper cross which doesn’t slow down trains.
This construction makes it possible to cross 4 tracks (2X2), for example a typical mainline (LL__RR) near a station area or to split some tracks going at wrong points. Of course this works also with only two tracks (1X1), but its not worth to show it.
The keypoints:
+ very small (area is 6×19)
+ double bridges/tunnels don’t cause trains to jam
– it may cause problems with small trains (TL: 2/3, because bridges are quite long)
– its not in the stable releases, you need one of the newer OpenTTD nightlies
I’ll also add it to the Junctionary,
enjoy it and happy building
Categories: Community News
Ammler May 19, 2007 11:36
Diagonal bridges could make it smaller and cheaper…
Osai May 19, 2007 14:21
Of course,
but we don’t have diagonal bridges 🙁
Phazorx May 19, 2007 22:16
one more tile can be shaved off if southern tunnel exits go SW and then merge next to bridges rather than under… so i guess 6x18x3?
valhallasw May 26, 2007 21:16
I fail to see the need for those huge bridges. A version with smaller bridges doesn’t need double bridges and hence can be smaller. Find it at http://openttdcoop.ppcis.org/wiki/index.php/Image:Junction2.png
The right one is a version with single bridges (7×11), the left one with double bridges (9×20). Both are slightly wider, but not nearly as wide as a full cross. And no problems with small trains 😉
valhallasw May 26, 2007 22:35
With some minor actions (placing the bridges right next to eachother; buildonslopes is needed), it is possible to shrink them to (6×10) and (7×16), respectively